Projects / Generative Bamboo Installations

Generative Bamboo Installations

Generative Bamboo Installations

Generative Bamboo Installations were two student design-build projects for the Living-Learning Community in Virginia Tech's Creativity and Innovation District, completed in 2021: a bamboo and lime plaster wall for the makerspace and a bamboo ceiling for the faculty apartment. They put into practice research on bamboo as a low-impact building material, using the iron bamboo Dendrocalamus strictus and generative design to lay out poles of irregular shape.

In the makerspace wall, plaster was cast over rubber membranes stretched across crossing bamboo poles, so the weight of the plaster shaped each panel and the poles left their imprint in it. The poles stay in place as the outer layer of the finished wall.

The projects were led by Jonas Hauptman and his BioDesign Research Group, with Stefan Al and Walter Zesk as faculty contributors and Sara Saghafi Moghaddam as computational design mentor. Undergraduate students from Architecture and Industrial Design managed the work and fabricated the installations; Tony Lin and Mason Millner were student leads on the wall. Supported by the AIA Upjohn Research Initiative.

Makerspace wall. Photo: Chiravi Patel
Close view of bamboo poles crossing in front of white plaster panels
Poles and cast lime plaster panels. Photo: Chiravi Patel
Low-angle view of bamboo poles rising past curved plaster panels
Looking up the wall. Photo: Chiravi Patel
Bamboo poles of irregular shape against plaster
The irregular poles keep their natural shape. Photo: Chiravi Patel
Exploded isometric drawing of a wall panel
Exploded isometric of a wall panel: frame, plaster membrane and bamboo poles.
Section through the bamboo and plaster wall beside a standing figure
Section through the wall.
Plan of the curved wall with its panels and bamboo
Plan of the wall corner.
Students in hard hats lifting the bamboo ceiling into place
Students installing the bamboo ceiling